Equipment
UNI - all in one applicator
UNI Spec Sheet — PDF
- DESCRIPTION
- Applicator designed for the prototyping engineering group or the multiple terminal short run manufacturers.
- CRIMPING HEIGHT
- 135.8mm (5.346")
- STROKE
- 30mm or 40mm (1.180/1.575")
- WIRE SECTION
- 102 mm
- MAX TERMINAL THICKNESS
- 1.2 mm (.047")
- FEEDING SYSTEM
- Manual
- Crimps different terminals in small batches.
- The set up time of the UNI Applicator stays in minutes.
- Can be supplied either with a continuous or a four-pad regulating head.
- Non-resettable 7-digit cycle counter.
- Additional quick change tooling shuttle available upon request.
- To be used on special P107C Mecal press or with press adapter.
PSMC107 - Programmable Stripping & Crimping Machine
PSMC107 Spec Sheet — PDF
- PART NUMBER
- 8Z3500800
- AIR PRESSURE
- 5-7 bar
- DIMENSION (mm)
- W 840 x H 880 x D 460
- DIMENSION (")
- W 33 x H 34.65 x D 18.11
- WEIGHT
- 100 Kg (220 lb)
- POWER
- 0.55 KW (0.75 HP) single phase
- POWER SUPPLY
- different arrangements available
- WIRE RANGE
- 0.05 - 6.00 mm2(AWG 30 - 8)
- MAX INSULATION DIAMETER
- 6 mm (0.23")
- MAX STRIPPING LENGTH
- 12 mm (0.46")
- MIN JACKET STRIPPING LENGTH
- 15 mm (0.59")
- MAX TRIMMING LENGTH
- 4 mm (0.15")
- MAX BAD TERMINAL CUT OFF & ZERO CUT
- 6 mm2(AWG 8)
- CYCLE TIME
- 1.2 sec (5mm stripping. trimming. crimping)
- Fully programmable wire stripping and crimping equipment.
- Open barrel terminal with left side or rear feeding.
- 135.8 mm shut height Mecal standard Applicator.
- Any Western or Asian styled Applicator with different shutheight and stroke can be installed when using a dedicated Press set up (optional).
- State of the art features assure the highest quality crimping on a wide range of applications.
- Any wire from 0.05 to 6 mm2 can be trimmed, stripped and cut off in case of faulty crimping.
- All stripping slugs are collected by means of a suction device into a little tank outside the machine.
- Highest flexibility and best performances on the market.