Here are 4 common quality issues that you should monitor

1) Core Crimp Height: Mecal crimp height specs dictate that acceptable height/width ratios should be between 55% and 70%.
The height/width ratio affects the compaction ratio (this is the difference between the cross-section of the wire and terminal before and after the crimp itself). This should be between 17% and 24%. The Crimp Height and Compaction Ratio will affect the pull test.
2) Terminal Bend: Mecal crimp specs dictate that your terminal bend should be within 3 degrees left/right and up/down. Terminal bend that is out of spec may indicate other quality nonconformance issues such as centrality, bellmouth, and cut-off tab.
See our tutorial videos HERE on how to make Terminal Bend Adjustments.
3) Burr: If you notice a burr while you’re crimping you should immediately stop and inspect your crimp tools- this is an indicator of damaged crimp tools. If no damage is found, the burr must be less than or equal to the terminal thickness to be within specifications.
Burrs often cause issues when putting the terminated wire into housings.
4) Bellmouth: Bellmouths being out of tolerance can cause several problems- poor pull tests, shearing of wire strands, and improper fit into housings. Bellmouths should be at a minimum of .2mm and a maximum of .5mm.
You can find tutorial videos on Bellmouth adjustments HERE

For further questions and technical support, you can contact us HERE

For more on quality crimping, preventative maintenance, and other helpful information check out these links Here and Here